Study on tangent distance with SVD method for characters recognition fine classification;
切线距离的SVD方法在汉字识别细分问题中的研究
Based on practical field expericnces, this paper discusses the indirect determination method of the length of rails in joint areas and the computation of the length of the rail at a track bond,by the use of the principle of tangent offset.
根据现场实践经验，利用切线支距法原理，探讨拨接口区域线路钢轨长度的间接测定方法及龙口轨长度的计算方法。
There are many methods to measure the circular curved line in circuitry construction survey. Angle offset method and tangent offset method are usually used.
在线路施工测量中,圆曲线测设方法有很多,通常采用偏角法或切线支距法。
tangential position roentgenography of mandibular ramus
下颌升支切线位投照术
The lateral vertical cut should be 4 mm lateral to midline.
两侧的垂直切口各距离中线约 4mm。
An experimental study of truss cable support in cross roadway with big span in Xinsan Mine
新三矿大跨距切眼桁架锚索支护试验研究
Draw two tangents to the two branches of the curve.
画出该曲线两个分支的两条切线。
On Some Fixed Value Theorems of Directed Distance for Conic Sections
二次曲线外切多角形中有向距离的定值定理
System Evaluation of Intraluminal Brachytherapy(ILBT)Combined with Endoprostheses Comparied with Endoprostheses alone for Nonresectable Bile Duct Cancer
不可切除胆管癌近距离腔内放射治疗加内置支架与单用内置支架比较的系统评价
If you are forward of your position, your artillery will fall short.
你推进的位置距离防线越远﹐军的火炮支援就越到不了。
Eccentricity of curved continuous girder bridge and it's influence on bearing reaction
曲线连续箱梁桥的偏心距及其对支座反力的影响
A short distance measured perpendicularly from the main line in surveying, used to help in calculating the area of an irregular plot.
支距在测量中，从主线垂直测得的一个短的距离，用以帮（辅）助计算一不规则的小块土地之面积
Fiber laser precision cutting of stainless steel stent of high linear density
光纤激光精密切割高线密度不锈钢支架
Linearity (time or distance)
线性(时间或距离)
tangental acceleration
切线[切向]加速度
coarse threading attachment
大螺距螺纹切削装置
A line connecting isometric points.
等距线连结等距各点的线
Study of Reasonable Minimum Spacing and Supporting on Small Clear Distance Tunnel;
小净距隧道最小合理净距及支护研究
hinged-hinged beam
两端铰支梁(端距不变
gap between income and outgo; the spread between lending and borrowing costs.
收入和支出的差距太大。
