Experimental and theoretical study of skew bridge backwater;
斜交桥壅水试验研究与理论探讨
Calculation method of the skew bridge in the polar coordinates;
斜交桥极坐标系下的计算方法
3D beam-grid model and entity-element model are used to calculate a prestressed skew-beam bridge.
同时采用空间梁格模型和实体单元模型,对一座斜交角较大的预应力混凝土连续斜交桥梁进行模拟计算。
A calculating formula of the best intersecting angle of oblique bridge and culverts can be worked out in theory according to the principle of less cost buliding and ensuring water flowing unblockedly when bridge and culvert oblique being designed necessarily because of the limit of real topography conditions.
由于实际地形条件的限制 ,必须设计桥涵斜交时 ,按照保障流水畅通 ,最大限度降低工程造价的原则 ,可从理论上推导出桥涵斜交之最佳交角的计算公式 ,再根据当地之地形条件确定桥涵之最佳位置。
Obique bridge is made up of main girder crossbeam and bridge floorings.
斜交桥由相互斜交的主梁、梁及桥面板组成,结构受力复杂。
Research on the Flow and Scour Characteristics of the Skew Bridge at the Downstream of the River Bend;
河湾下游斜交桥水流及冲刷特性研究
Computation of the Influence Lines for Lateral Load Distribution in Straight, Skew and Horizontal Curved Bridges Using Rigid-Diaphragm Method
用刚性横梁法计算直交桥、斜交桥及平面弯桥的荷载横向分布影响线
The Finite Element Nonlinear Analysis of Cracking and Reinforcement for Gravity U-Shaped Skew Abutments;
重力式U型斜交桥台开裂与加固的非线性有限元模拟分析
The block water characteristics and backwater height of skew bridges are experimentally studied with the sketch model of the Hegong bridge of a speedway.
应用合共公路桥的概化模型试验研究了斜交桥的阻水特性、壅水高度。
Characteristic Analysis of the Skew Slant Leg Rigid Frame Bridge Without Abutment;
斜交无桥台斜腿刚架桥的受力特性研究
On the Influence of Abutment Torsional Stiffness and Width-span Ratio to the Stress of Skew Arch Bridge
桥台抗扭刚度及宽跨比对斜交拱桥受力的影响
Analysis on the Vehicle-Bridge Coupling Vibration of Multi-Spans Skew Simply-Supported T-Beam
多跨斜交简支T梁桥车桥耦合振动分析
The linearis monitoring under skew continuous box girder bridges cast with balanced cantilever method
悬臂浇注斜交连续箱梁桥的线形监控
Study on Consolidation Method of Gravity Oblique High U-shaped Abutment;
重力式斜交U型高桥台加固方法研究
Finite Element Analysis of Skewly-Supported Continuous Box Girder Bridge with Variable Section;
斜交变截面连续箱梁桥的有限单元法
Load-carrying capacity analysis of a skew prestressed hollow slab bridge after widening construction
斜交预应力空心板桥拓宽承载力分析
DYNAMIC CHARACTERISTIC ANALYSIS OF THROUGH SKEWED ARCH BRIDGE WITH CURVED BEAM
下承式曲线梁斜交拱桥动力特性分析
The Impact Analysis of Skew Angle on the Simple Supported Inclined Plate Assembled Concrete Bridges;
斜交角度对装配式钢筋混凝土简支斜交板桥的影响分析
The Bending Theory of Skew-anisotropic Plates and Its Application in Skew Girder Bridges
斜交构造异性板的弯曲理论及其在斜桥上的应用
A PLATE AND BEAM FINITE ELEMENT ANALYSIS FOR OBLIQUE FRAMED TUNNEL BRIDGES
斜交箱形地道桥空间分析的板梁有限元法
This paper outlined an analysis of a skewed box calvert by thick shell finite element method.
本文提出了斜交箱形涵桥厚壳元分析方法。
Analysis of Torsional Moment to Oblique Separation Framed Tunnel Bridges by Finite Element Method of Plates and Beams
斜交箱形地道桥扭矩分析的板梁有限元法
