The relationships of the self-sealing pressure of two types of direct acting gas regulators to its structural characteristics and inlet pressure are analyzed.
分析了两种直接作用式燃气调压器的自封压力与其结构特性和进口压力的关系,探讨了进口压力变化对两种调压器自封压力变化影响的差异。
This experiment focuses on the influence of inlet pressure and consistence to performance of hydrocyclone including output,separation efficiency,separation precision etc.
本实验研究了水力旋流器的进口压力与浓度对旋流器性能的影响,包括生产能力、分级效率、分级精度、分级粒度等指标。
Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.
通过从最大进口压力减去所需要的出口压力来计算压差。
For compressible fluids, where pressure drop exceeds half the inlet pressure.
对于可压缩性流体，如果压降超过进口压力的一半。
Essentially balanced single seat minimizes a variation in delivery pressure resulting from a varying inlet pressure.
基本平衡单阀座最大限度减小进口压力变化对输出压力的影响。
Hydraulic power modules imported from Europe and USA.
油压动力单元选用欧美进口之零组件。
42LE PRESSURE PORT LOCATIONS
４２ＬＥ压力端口定位
Construction of pressure dispersion-type anchorage cable at intake vertical side slope
进水口垂直边坡压力分散型锚索的施工
Imported closed compressor was applied, better efficiency, and better refrigeration.
采用进口全封闭压缩机，效率高、冷冻能力强。
Design of upper water inlet/outlet penstock for Yixing Pumped-Storage Power Station
宜兴抽水蓄能电站上进/出水口压力钢管设计
The Effect of the Variable Load on the Pressure of the Hydraulic Cylinder in the Entrance Throttle Governing System;
进口节流调速系统负载变化对液压缸压力的影响
Study of Turbine HP Inlet Pressure Control for Nuclear Power Plant
核电站汽轮机高压缸入口压力控制模式改进研究
After selecting valve size, locate inlet and outlet pressures on this chart.
阀门通径选择后，在这个图表中找出进口和出口压力。
Improved learning algorithm for CMAC and its application on booster-pump pressure control
改进CMAC算法及其在接力泵进出口压差控制中的应用
This pressure closes the reed valve so that further downward movement of the piston compresses the trapped air-fuel mixture in the crankcase.
当活塞向下运动直到露出进气口,可燃混合气所具有的压力使其上升,通过进气口进入气缸。
compressor inlet vane assembly
压缩器进口叶片组件
exhaust gas intake port
（气波增压器）排气进口
loss of head due to entrance
管进口段的压头损失
An example shows that using this method can obtain a uniform velocity profile across the die and minimize pressure drop.
通过算例表明,应用该法进行口模优化设计可以减小压力降和口模出口速率变化率。
The inlet and outlet pressures of the adsorber and the pressure of oxygen tank of a pressure swing adsorption oxygen generator were studied experimentally.
对微型变压吸附制氧系统的吸附器进出口和储气罐内的压力进行了实验研究。
