In this paper, the physical characteristics of rice husk and char particles prepared under different gasification processes were studied by physical adsorption/desorption measurements of N2 (-196℃), mercury intrusion porosimetry (414 MPa) and true density measurement (He).
本文通过氮气等温吸附/脱附法(-196℃)、压汞法(414MPa)、真密度仪(He)等详细研究了在气化条件下谷壳的物理结构的演化,同时利用元素分析和傅里叶红外对颗粒化学结构进行分析。
Pore volume fractal dimensions of fly ash - cement paste at different ages and its pore volume fractal dimensions were determined by MIP(mercury intrusion porosimetry) on experiments.
采用压汞法对不同龄期粉煤灰-水泥浆体的孔分形结构进行了实验研究,测定了复合浆体孔体积分形维数,探讨了孔体积分形维数与孔隙率,孔表面积、平均孔径、孔分布及宏观力学性能的关系。
In this study, the mercury intrusion porosimetry (MIP) tests were performed on the natural sedimentary diatomaceous soil to investigate the relationship between the change in entrance pore size distribution and the applied stress level.
采用压汞法研究了不同固结压力作用下具有强结构性的天然沉积硅藻土的微观孔隙入口孔径分布与应力水平的关系。
The determination of phosphorus pentachloride by mercurimetric titration;
汞量法测定五氯化磷含量
In order to characterize quantitatively the microstructure of freeze-dried material, the computational method of surfacefractal dimentsion through mercury intrusion is introduced.
研究表明:采用压汞法能够简便和合理地获得冻干物料的表面分形维数,可采用表面分形维数对冻干物料内部孔隙结构的粗糙和复杂程度特性进行定量描述;冻干物料的表面分维值主要与物料的孔隙分布特性有关,小孔的体积份额越大,物料的表面分形维数也越大。
In order to represent structure and shape of pores in freeze-dried materials quantitatively, based on mercury intrusion, two fractal models of porous media were employed to characterize pores in freeze-dried bovine muscle and cured beef.
为了定量表征冷冻干燥物料孔隙结构和形貌特性,采用两种多孔介质分形模型,通过压汞法研究冻干牛肉和冻干腊牛肉孔隙结构的分形特性。
mercury intrusion pore size distribution
压汞法孔隙大小分布
The micropore content was measured by mercury porosimeter.
用压汞法测定了拉伸丝的微孔含量。
Nitrogen Adsorption Method and Mercury Injection Method Determination the Pore Structure of Alumina Carrier
氮气吸附法和压汞法测定Al_2O_3载体孔结构
Investigation of Pore Structures of C/C Composite Plates by Mercury Intrusion Method
压汞法分析C/C复合材料平板的孔隙结构
Fractal study of low permeability reservoir based on constant-rate mercury injection
基于恒速压汞法的低渗透储层分形研究
Test methods for the characteristics of getter-mercury dispenser--Method for peel off test of getter-mercury dispenser
GB/T6626.4-1986释汞吸气剂性能测试方法释汞吸气剂压粉牢固度的检验方法
capillary pressure withdrawal curve
退汞毛细管压力曲线
shows pressure by the height of a column of mercury.
由汞柱的高度测量气压。
Silicon epitaxial layers--Determination of carrier concentration--Mercury probe Voltage-capacitance method
GB/T14146-1993硅外延层载流子浓度测定汞探针电容-电压法
Simultaneous determination of the content of Methyl mercury,Ethyl mercury and Inorganic mercury in water samples by HPLC-ICP-MS
HPLC-ICP-MS法测定水样中的甲基汞、乙基汞和无机汞
Test methods for the characteristics of getter-mercury dispenser--Test method for mercury content of getter-mercury dispenser
GB/T6626.2-1986释汞吸气剂性能测试方法释汞吸气剂含汞量的测试方法
Test methods for the characteristics of getter-mercury dispenser--Test methods for mercury yield characteristic of getter-mercury dispenser
GB/T6626.1-1986释汞吸气剂性能测试方法释汞吸气剂释汞特性的测试方法
RESEARCH ON DETERMINATION OF COD IN HIGH CHLORIDE WATER BY MERCURY-FREE,HIGH-SILVER,LOW-PRESSURE DIGESTION METHOD COMPARED WITH CHLORINE EMENDATION METHOD
无汞高银低压消解法与氯气校正法测定高氯水体中化学需氧量的比较研究
Simultaneous Determination of Lead and Mercury in PVC by Sealing Digestion AFS-230E
高压密封罐消解双光道原子荧光光谱同时测定PVC中铅和汞的方法研究
Measure of mercury spectroscopy in mercury-cefazolin sodium system;
汞-头孢唑林钠体系中汞的分光光度法测定
Direct Determination of Mercury in Cutting Fluid and Machining Process Waste Fluid
切削液和机床排泄物中汞的测定-直接测汞法
Decrease of consumption and pollution of mercury in PVC Industry by calcium carbide method
电石法聚氯乙烯生产中汞消耗与汞污染的降低
"Pressure Rating to 250 PSI, Vacuum to 28"Mercury"
压力等级为250PSI,真空下为28英寸汞柱。
