PID Control and Influence Research of Relevant Parameters of Laser-Controlled Separation;
PID法控制激光热应力切割及相关参数的影响研究
Simulation and Control of Laser-Controlled Separation of Brittle Materials;
脆性材料激光热应力切割的仿真与路径控制研究
Methods of cutting should be employed which are unlikely to generate an undue amount of heat.
应采用不易产生过多热量的切割方法。
Design of Annular Slot Cutting Tool Used in Rock Stress Measurement with Borehole-wall Stress Relief Method
钻孔局部壁面应力解除切割工具设计
hot-wire cutting
(平板玻璃的)热金属丝切割法，火线切割
After cutting, shear section shall be checked for no lamination and shear crack.
切割后，应检验切割部分有无夹层，切割裂纹。
Application study on ultrahigh pressure abrasive waterjet cutting equipment
超高压力磨料水射流切割机的应用研究
The Current Effect and Acceleration When the Conductor Cuts the Magnetic Lines of Force Variably;
导体变速切割磁力线时的电流效应和加速度
Study on Stress Control in Multi-wire Sawing Process
多线切割机加工过程中应力控制的研究
Research on Broken Wire Caused by Thermal Effects in Micro-WEDM
微细电火花线切割加工热效应引起断丝问题的研究
Need no preheating time. Rapid cutting time( only2~5 times) compare with gas cutting.
不需预热；跟气割比较，切割时间缩短2-5倍。
The General Equation of Actual Cut-area of Cutting off Cuboid and Its Application;
方体截断切割实际切割面积的一般公式及应用
Application of FIKUS WEDM Machine in Low-Speed Wire Cutting Program
FIKUS线切割机在慢走丝线切割编程中的应用
He is cutting the steel plate that the heat treatment is crossed.
他正在切割热处理过的钢板。
Study on the Open Architecture NC Software for Torch-Cutting Machine;
开放式热切割机数控软件系统的研究
Effect and Elimination of the Grinding Heat of Multi-wire Saw
多线切割机磨削热的不良影响及消除
Since the cope is usually made by flamed cutting, a high residual tensile stress exists along the burned edge.
由于修割工作通常用火焰烧割，沿着烧切边缘就存着较高的残余拉应力。
Foam Cutter can do everything for you, the only limit is your imagination.
我们的切割机能为你切割一切，您只需发挥你无尽的想象力。
