Fungiform configuration was used in the main LOX valve to meet the demand of gas generator hot test system.
根据发生器热试系统的要求,设计的液氧主阀采用菌阀结构,通过结构设计使阀门具备主动关闭功能,产品经过常温和低温的验收试验检查,满足发生器热试要求。
This paper reviewed recently development of researches for high performance of zinc oxide varistror,including researches for the discharge capability and high current surge withstanding capability,and the trend of high performance of zinc oxide varistror was also pointed out.
文章综述了近年来高性能氧化锌阀片研究的最新进展,包括氧化锌阀片通流容量和阀片侧面耐大电流性能方面的研究进展,并且指出了高性能氧化锌阀片未来发展趋势。
Valves for oxygen cylinders
GB10877-1989氧气瓶阀
Valves for argon cylinders
GB13438-1992氩气瓶阀
accumulator air-charging manifold
蓄压器充气阀箱压缩空气瓶充气阀箱
Valves for dissolved acetylene cylinders
GB10879-1989溶解乙炔气瓶阀
Valves for liquefied petroleum gas cylinders
GB7512-1998液化石油气瓶阀
Liquid cylinders designed to dispense gaseous oxygen have valves equipped with standard Compressed Gas Association (CGA) outlets.
设计用来输出气态氧的液体钢瓶上装有配有标准的压缩气体协会排气口的阀门。
Air tightness test and safety valve adjusting for main air receiver( control air receiver, air horn receiver) on board.
主空气瓶（制空气瓶、笛空气瓶）船后气密试验和安全阀的调整。
Outlet connections and sizes for cylinder valves
GB15383-1994气瓶阀出气口连接型式和尺寸
General technique specifications for cylinder valves
GB15382-1994气瓶阀通用技术条件
Safety valves for marine air vessel
GB/T14087-1993船用空气瓶安全阀
Medical Gas Cylinders with Post-Type Valves
带有柱型阀门的医用气体钢瓶
Replace the cylinder outlet seal and valve cap.
替换钢瓶排气口密封和阀门帽。
The gas distribution system shall cover from the gas outlets on the benches or fume hoods to gas regulator manifolds at the cylinder area.
气体管路安装从气瓶站总阀门到工作台上各个气体阀门。
When returning cylinders to the supplier, properly close the cylinder valve, replace and secure any valve outlet seals, and properly install the cylinder cap.
钢瓶返还给供应商时，正确关闭钢瓶阀门，替换并固定阀门排气口密封，正确安装钢瓶帽。
11 Adapters to convert cylinder valves from one type of gas to another can lead to contamination and serious accidents. Their use is forbidden.
使用将一种气体瓶阀转换成另一种气体瓶阀的接头，会导致气体污染和严重事故，严禁使用。
Oxygen control valves consist of valve, actuator and accessories.
氧气调节阀由阀门,气动执行机构及附件组成.
After fitting of the valve, the valve should be maintained in a closed position to prevent any contamination from entering the cylinder.
连接好阀门后，阀门应保持关闭位置，为防止任何污染进入气瓶。
There should be a system in place ensuring traceability of cylinders and valves.
应有一个确保气瓶和阀门的可追溯系统。
