Design and manufacture of the flexible joint for 110 kV submarine oil-filled cable;
110kV海底充油电缆软接头的设计与试制
Mechanical analysis of segment joint of shield tunnel and research on bilinear joint stiffness model;
盾构衬砌管片接头力学分析及双直线刚度模型研究
The numerical simulation of segment joints of Nanjing metro shield tunnel was carried out with 3D FEM (finite element method).
采用三维有限元法对南京地铁区间盾构隧道管片接头的受力情况进行了数值模拟计算,研究了不同荷载作用下管片接头的变形、转角和抗弯刚度,探讨了接头转角和抗弯刚度的变化规律;通过转角、弯矩和轴力关系的拟合为接头抗弯刚度的确定提供了新的途径。
When simulating the mechanical behavior of segment joints,it is necessary to build a model that is the same with actual joints so as to avoid multiple tolerances.
管片接头是装配式盾构隧道的关键部分,其抗弯刚度对管片环的内力及整体性能均有重要的影响,使得接头抗弯刚度的取值显得尤为重要。
Study on the Softening Problem of Mobile Flash-butt Welding Joint
钢轨移动闪光焊接接头软化问题的研究
Quick hose' s connection
GB/T16693-1996软管快速接头
engine water outlet hose connection
发动机出水软管接头
4"H.T. Hose Connection which easily attaches to an outside hose bibb or to the drain connection on a water heater.
软管连接，容易连接到外置软管水龙头或热水器的排放接头。
Hose connection for equipment for welding and cutting
GB/T5107-1985焊接和切割用软管接头
Some bullet-nose connections have soft tips or O-rings on the nipples.
一些弹头接头具有一个软头或在管接口上有O形圈。
Key words: hose-connect、 injection mould、 take off whorl、 side core.
关键词：软管接头、射模、螺纹、向抽芯.
It is essential to use a new gasket each time the connection is tightened because the softened nickel washer becomes hardened after each compression.
因为在每次压缩之后软化的镍垫圈会变硬，每次接头上紧时必须使用新衬垫。
Air intake and air outlet of motors use metal hose expansion joint; Entrance and exit of pump use rubber flexible connectors.
风机进出风接口处均设金属伸缩软管柔性接头；水泵进出口均设橡胶软接头。
" Motor vehicles-Hydraulic braking systems-Pipes tapped holes, male fittings and hose end fittings"
GB/T11611-1989汽车液压制动系金属管、内外螺纹管接头和软管端部接头
Some bullet-nose connections have a soft tipped nipple or an O-ring on the nipple to improve the seal.
一些弹头接头具有一个软头管接口或在管接口上有一个O形圈，以改善密封。
The cartilaginous cranium of an embryo before ossification.
软骨颅胚胎在骨化作用之前的软骨性头颅
A cartilage disk that acts as a cushion between the ends of bones that meet in a joint.
半月板行动象关节中骨头相接处臀肉的软骨
Key words: hose-connect、 injection mould、take off whorl、 side core.
关键词：软管接头、注射模、脱螺纹、侧向抽芯.
Reattach the relief valve hose to the elbow in the bottom flange cover.
重新将安全阀软管接到底部法兰盖内的弯头上。
The Effects of Soft-diet Feeding on the Development of Neuromuscular Junction of Masseter Muscle in Rat;
软食喂养对大鼠咬肌神经肌肉接头发育的影响
The CAT System Software Design for Internal Thread of Joint;
油套管接头螺纹CAT系统软件的设计与开发
The development of simulation software of three-cone bit based on DLL technology
基于动态链接库的三牙轮钻头仿真软件开发
