Then the mechanism of the preload of file , which can improve system efficiency effectively ,is also designed.
文中还设计了能有效提高系统效率的文件预装载机制，讨论了这一机制的原理和具体实现。
According to the working mechanism of the normal section rupture of reinforced concrete beams,the effects of reforce on the height of the limited pressurized region of steel-strengthened concrete beams under different unloading conditions(that is,under both the incompletely unloading and completely unloading conditions)are analyzed in the paper,with the differences in the height formulae inferred.
根据钢筋混凝土梁的正截面破坏的作用机理,分析了不同卸荷条件下二次受力对粘钢加固混凝土梁界限相对受压区高度ξb的影响,推导出了再受力情况下(即不完全卸载与完全卸载条件下)ξb公式的差异。
Due to the difference in stress paths between the loading and unloading conditions, it is unsuitable to apply mechanical model under loading condition to stability of tunnel excavation.
由于岩体在加载和卸载条件下应力路径的不同,仅采用加载条件下所建立的力学模型来研究隧道的开挖稳定性问题是不适合的。
Study on the Mechanical Properties of Rock Discontinuity under Unloading
结构面在卸载条件下的力学特性研究
C.I.F. landed terms
到岸价格加卸岸条件
Could not uninstall the %1 component. %1 is still required by the following component(s) and cannot be uninstalled until those components are uninstalled: %2
未能卸载 %1 组件。下列组件仍旧需要 %1，在卸载这些组件之前不能卸载: %2
The software for the green software, installation and unloading 100 percent no residue.
本软件为绿色软件，安装卸载100%无残留。
Uninstalling a component removes it from all network connections. Are you sure you want to uninstall %1?
卸载一个组件会将其从所有网络连接上删除。确实要卸载 %1 吗?
Uninstalling a component removes it from all network connections. Are you sure you want to uninstall %1?\0
卸载一个组件会将其从所有网络连接上删除。确实要卸载 %1 吗?\0
Please wait while Setup uninstalls components.
请稍候，安装程序正在卸载组件。
Could not uninstall the %1 component. The error is %2.\0
未能卸载 %1 组件。错误是 %2。\0
A temporary unload file cannot be created or is corrupted.
一个临时卸载文件无法创建或已损坏。
The uninstall files must be save on a local hard drive
卸载文件必须保存在本地硬盘上
The uninstall files must is save on a local hard drive.
卸载文件必须保存在本地硬盘上。
Module Unload: %s.
模块卸载: %s.
A temporary unload file cannot be created or is corrupted.\0
不能创建临时卸载文件或该文件已损坏。\0
Specification for the operation of the swing used in the port cargo handling
GB14736-1993港口装卸用吊环使用技术条件
Specifications for the operation of hook used in the port cargo handling
GB14735-1993港口装卸用吊钩使用技术条件
arrival notice
抵港通知书(声明已具备装卸货条件)
The position of the last crack is marked before unloading the beam.
标出最后一条裂纹的位置，然后卸去载荷。
This method is used to dismount a volume from the file system.
此方法用于将一个卷从此文件系统卸载。
