您的位置:汉字大全 > 行业英语 > 海洋 > maximum support clearance是什么意思

maximum support clearance是什么意思

中文翻译最大支承间隙

网络释义

1)maximum support clearance,最大支承间隙2)pedestal looseness,支承间隙3)maximal clearance,最大间隙4)maximal brazing clearance(MBC),最大钎焊间隙(MBC)5)maximum clearance permitted,允许最大间隙6)maximum axial clearance,轴向最大间隙

用法例句

    This model is engaged with integrated hydraulic system, which illustrates robust performance.

    ◆ 采用三点支承滚动导轨,消除支承间隙,提高剪切质量。

    Bearing Clearance (#1 Journal)

    轴承间隙(#1轴颈)

    A loaded pin bears on a hole with small clearance.

    一个受载销钉支承于一个具有微小间隙的孔上。

    Measure bearings for correct clearance

    测量轴承以校正间隙

    Influence of bearing stiffness and backlash on bifurcation and chaotic of spiral bevel gear transmission system

    支承刚度和啮合间隙变化时弧齿锥齿轮传动系统的分岔与混沌行为

    Lubricating spindles with narrow bearing clearance in machine tools.

    亦可用作润滑机械工具中,狭窄间隙轴承的轴心。

    The Application of a Single Chip Processor 8098 to Detecting the Axial Clearance of a Bearing

    8098单片机在轴承轴向间隙检测中的应用

    The Limit Bearing Capacity for Gap K-Joints of Steel Lipped Channels Trusses;

    卷边槽钢桁架K型间隙节点的极限承载力

    Analysis on the Problem of Axial Clearance Installation of Tail Pipe Beam of Certain Aircraft

    某型飞机平尾管梁轴承轴向间隙问题的分析

    399 How many radial (axial ) clearnance are there in this bush (journal bearing , thrust bearing) ?

    这个轴套(轴颈轴承、止推轴承)的径向(轴向)间隙是多少?

    Dynamic Behavior of a shaft-rolling bearing system with clearance

    计入轴承间隙时轴-滚动轴承系统动力学行为研究

    lower high water interva

    低高潮间隙低高潮间隙

    gap(p)ing of joints

    连接间隙, 接缝间隙

    A gap or space between two teeth.

    齿隙两齿之间的间隙或空隙

    Attempt to improve efficiency of guide bearing gap by brainstorming

    头脑风暴法提高机组导轴承间隙测调效率的尝试

    The diaphragm was clamped between two support housings.

    隔膜被夹紧在两个支承套之间。

    No retrofit holes had been installed at the interior support.

    在中间支承上没有设置止裂孔。

    The Research on Bearing Spacing and Bearing Stiffness of Urban Rail Transit;

    城市轨道交通钢轨支承间距与支承刚度相互关系的研究

Copyright © 2022-2024 汉字大全www.hanzidaquan.com All Rights Reserved 浙ICP备20019715号