Study on charge circuit of capacitor stored energy spot welding machine with high output energy;
大容量电容储能点焊机充电电路研究
Design of circuit about new capacitor stored energy spot welding machine;
一种新型电容储能焊机的电路设计
Taking the welding couple with samll section area of mild steel and pure copper for example,the influence of the parameters of capacitor discharge welding on the joint quality has been studied by means of the orthogonal regression method ,which provides a scientific basis for selection reasonable welding parameters.
以小截面低碳钢—紫铜焊接对偶为例 ,利用正交实验方法研究了电容储能焊规范参数对接头质量的影响规律 ,为规范参数的合理选择提供了科学依据。
Develop of Waveform Control Inverter and Capacitor Discharge Spot Welding Machine;
波形控制的逆变式电容储能点焊机的研制
Capacitance Pulsation Welding on PLC Control;
基于PLC控制的电容储能脉冲焊机
electrostatic energy storage spot welder
静电能量贮存式点焊机
Analysis of film capacitor's performance on inverter welding machine
逆变焊机选用薄膜电容器的性能分析
electrode ,metal contact, for welding machines
电焊机金属接点焊条
Research on Simulation of Starting Diesel Engine of Locomotive with Super Capacitor;
采用储能电容的机车柴油机启动系统仿真研究
Development on the Intelligent Controller of Resistance Spot Welding with Single Chip Microcomputer;
采用单片机的电阻点焊智能控制器开发
hydromatic welder
水力导向焊条顺序夹持多点电焊机
Super Capacitor Energy Storage Device and Its Study for Improving Generator Operation Stability
超级电容器储能装置及其对改善发电机运行稳定性的研究
Analyzing Energy Release and Power Supply Time about Certain Capacity Gasholder of Air-powered Generator Set
气动发电机组定容储气罐能量释放与供电时间分析
YS Automatic Girth Welder (YS-AGW-I/II) is mainly used in horizontal girth inside / outside welding of large tanks、vessel etc. The welder applies submerged arc welding.
型埋弧自动横焊机采用埋弧横向焊接工艺，主要用于大型储罐、容器等内外环缝的焊接.
Research on Voltage Balance of Supercapacitor Storage Energy System;
超级电容器储能系统电压均衡的研究
Research on Control of the Energy System Based on Super Capacitors;
超级电容器储能系统发电控制的研究
Research on Insulation Failure Mechanism and Measurement Technology of High-Voltage Storage Capacitors;
高压储能电容器绝缘失效机理及测试技术的研究
Comparison of joint performance between weld-bonding and resistance spot welding of dual-phase steel
双相钢胶焊与电阻点焊接头性能对比分析
A new construction and advanced function high voltage source is used for electron beam welder (EBW), and designed on the principle of electromagnetic compebility (EMC).
提出了一种根据电磁兼容原理设计的新型高性能电子束焊机用高压电源。
Compensating Conservation of Parallel Condenser of AC Arc Welder and Its Calculation
交流弧焊机并联电容补偿节电及其计算
Research on PLC based medium frequency inverter resistance spot welding machine
基于PLC的中频逆变电阻点焊机研制
