The result showed that the low-cycle fatigue cycle characteristic of the material is cyclic softening under the experimental condition and the softening velocity increases with the increasing of strain amplitude.
对利用驰豫-析出-控制相变(TMCP+RPC工艺)技术获得的800MPa级超细晶粒低合金高强度钢的低周疲劳性能进行了测试,并对其循环特性和疲劳断口进行了观察和分析,发现该材料为循环软化,而且随着应变幅的提高,材料的软化速率逐渐增大。
Analysis of cycle characteristics of 9Ni steel showed that,for all three kinds of heat treatment,there was no obvious cyclic softening phenomenon or cyclic hardening phenomenon at low strain amplitude;however, the fatigue cyclic characteristics of 9Ni steel were all cyclic softening at high strain amplitude,and in which it was most serious for QT1.
通过对循环特性的分析发现,三种热处理制度下,9Ni钢在低应变幅下都未表现出明显的循环软化或循环硬化现象;而在高应变幅下均表现为循环软化,其中热处理制度QT1循环软化最为严重。
This paper,taking a continuous heat recovery adsorption air-conditioning system/heat pump as study object,through dynamic analysis on system cycle characteristics,lists a series of dynamic equations about system main components such as adsorber,heat source,condenser,evaporator and so on.
以连续回热型吸附式空调 /热泵为研究对象 ,通过对系统循环特性的分析 ,给出了吸附床、热源、冷凝器、蒸发器等主要部件的动态方程 。
The plastic deformation of the main parts of the automotive chain and the cyclic characteristics of its wear surface were investigated.
通过汽车发动机总成试验,研究了汽车链的磨损机制和磨损伸长率,分析了销轴和套筒磨损表面的微观形貌和滚子材料的金相组织,探讨了汽车链主要零件的塑性变形和磨损表面的循环特性,并通过联结牢固度的压出力试验阐述了汽车链过盈配合表面的微动磨损现象及其原因。
Study on the Characteristics of Solid Internally Circulating in the CFB-FGD;
烟气循环流化床脱硫塔物料内循环特性研究
Uniaxial Strain Cyclic Behaviors of 40Cr and 16Mn Steels at Room Temperature
40Cr钢和16Mn钢的室温单轴应变循环特性
Effect of Nozzle on Solid Particle Circulating Characteristics in Liquid-solid Exterior Circulating Fluidized Bed
喷嘴对液固外循环流化床内颗粒循环特性的影响
OPTIMAL PERFORMANCE CHARACTERISITICS OF THE REGENERATIVE FERROMAGNETIC ERICSSON REFRIGERATION CYCLE
铁磁回热Ericsson制冷循环性能特性优化
Heat and Mass Transfer Characteristics in the "Zeolite-Water" Closed Adsorption Cycle
“沸石-水”封闭吸附循环的传热传质特性
On the deformation of soft clay subjected to cyclic loading
循环荷载作用下软黏土变形特性研究
Investigation on Novel Externally Fired Humid Air Turbine System and Its Performance;
新颖外燃式燃气轮机循环与特性研究
Investigation on Water Wall Wear Characteristics of Circulating Fluidized Bed Boiler;
循环流化床锅炉水冷壁磨损特性研究
The Investigation of Operating Property of Circulating Fluid Bed Boiler in Variable Conditions;
循环流化床锅炉变工况运行特性研究
The Study of the Performance and the Reformation of Circulating-Pump in District Heating System;
大型热网循环泵改造及热网特性分析
Angles of Arrival Estimation Based on Cyclostationarity of Signals;
基于信号循环平稳特性的到达角估计
Blind Synchronization Algorithms for OFDM/OFDMA Based on Cyclostationarity;
基于循环平稳特性的OFDM/OFDMA盲同步算法
Characteristics Studies on Circulating Fluidized Bed Boiler's Loop Seal Components
循环流化床锅炉“J”型回料阀特性研究
Study of deformation of rock salt under cycling loading and unloading
循环加、卸载下盐岩变形特性试验研究
THERMAL CYCLING EFFECT ON SILICON SOLAR CELL STRUCTURE
热循环对硅太阳电池伏安特性的影响
An Analysis on the Emission Characteristics of Diesel Engines Meeting State-Ⅲ Emission Standard with ESC Test Cycles
国Ⅲ柴油机ESC试验循环排放特性分析
Research on Thermal Characteristics of 300MW Circulating Fluidized Bed Boilers
300MW循环流化床锅炉热力特性的研究
THE SUSTAINABLE CAPABILITY RESEARCH OF THE METAL OXYGEN CARRIER
金属载氧体可持续循环能力特性研究
