The advantage of the overmoded slow-wave structures (SWS) in enhancing power capacity is analyzed theoretically.
对过模结构在提高功率容量方面的优点进行了理论分析;分别采用解析方法和有限元方法研究了理想无限长过模慢波结构及有限长过模慢波结构色散关系的特点,对比了这两种情况下TM01模色散特性的区别,结果表明两者在纵向波数取值及对应的频率上有所差别,这对于高功率微波器件高频结构的设计有重要的参考价值。
WT5”BZ]The relations of power capacity of isolator to the material microstructure, properties are studied.
研究了器件功率容量与材料显微结构、性能的关系。
80GHz,the estimated value of the power capacity of the antenna is 0.
1dB,功率容量的估算值为0。
The power capability is an important parameter f or p-i-n diode control circuits.
PIN管控制电路的功率容量是一个重要的电路参数,必须全面考虑PIN管本身的功率容量和电路结构形式、施加的反向偏置电压、射频信号的频率和形式以及电路在系统中的匹配状况、工作环境和可靠性要求等各项因素综合确定。
Through the comparison among the effect on electric capability of microwave components from material properties,roughness grade,manufacturing and fixing tolerace, the paper describes the importance of them and provides some rational methods to keep the electric and power capability.
通过对微波元件材质、表面粗糙度、加工和安装误差对元件电性能的影响的比较 ,阐述其对保证元件电性能和系统功率容量的重要性并提出合理的解决方法。
The ingredients limiting power capability and depress combining efficiency in the whole system have been discussed.
讨论了功率合成系统中限制功率容量、降低合成效率的因素;详细研究了微带线尺寸对器件功率容量的影响,以及大功率合成系统中隔离电阻功率容量的量值;针对多路合成系统中适度恶化现象合成提出高效率的自适应合成方法。
Considering that the HPM antenna requires the feeds which have high power capacity and favorable radiation performance,the multimode and smooth-wall exponential horn is used.
利用内壁光滑的指数型多模喇叭满足高功率微波天线对馈源高功率容量和良好辐射特性的要求,并将介质透镜加载于喇叭馈源口面,以保证对天线副面进行平面波照射。
