Three technical parameters,the rotor speed,twist modulus and combing roller speed have great influence on the yarn quality of rotor spinning.
转杯速度、捻系数、分梳辊速度3项工艺参数对转杯纱的质量有较大的影响。
The effects of rotor speed, draft ratio and twist factor on the properties of elastic rotor-spun yarns were investigated, and the technology optimizing was done through the orthogonal test.
分析了转杯速度、牵伸倍数、捻系数对弹性转杯纱性能的影响,并通过正交试验对工艺参数进行了优化。
In order to find out the influences of three parameters (rotor speed,twist factor and combing roller speed) on the yarn quality in the process of rotor spinning,the parameters were optimized by a combination design with current and revolving capability for two times function.
通过三元二次通用旋转组合设计对转杯纺工艺参数进行了优化,结论是:对转杯纱强度、条干CV值、棉结3项主要指标而言,转杯速度、捻系数、分梳辊速度存在一个最佳组合,能使这3项主要指标达到最优值。
Analysis of Rotational Velocity Sensing Using Coupled Resonator Induced Transparency;
耦合谐振腔诱导透明用于旋转角速度测量分析
Concerning the dynamic with the discussion for angular velocity and angular acceleration of the rigid body rotation;
关于刚体转动的角速度和角加速度的讨论
What is the angular velocity after the ball has made five complete revolutions?
在球转了五整圈之后，角速度是多少？
Swivel table angular velocity verifying system based on fiber optic gyroscope
基于光纤陀螺的转台角速度检定系统
Fast Measurement Method for the Rotation Angle of MEMS Microstructures
MEMS微结构旋转角度的快速测量方法
Angle tracking velocity and acceleration
跟踪角速度和角加速度
Fast Rotational Motion Estimation Based on Modified Geometrical Algorithm
采用改进的几何算法快速估计图像旋转角度
Speed and Position Observer of DFIG Based on Rotor Current Vector Angle Deviation
基于转子电流偏差角的双馈感应电机速度观测
Study on feedback control of yaw angle rate based on active front steering
基于主动前轮转向横摆角速度反馈控制的研究
"The mechanical power for an electric generator is usually obtained from a rotating shaft and is equal to the shaft torque multiplied by the rotational, or angular, velocity (speed)."
一台发电机的机械动力通常来自一个转动轴,相当于轴转矩乘以回转的速度(或角速度)。
Coupled with your extra speed when drafting this can cause spin-outs in fast curves and can affect your braking too.
伴随高速度而来的可能是在高速弯角中打转，或者是刹车受到影响。
For a rigid body rotating about a principal axis, the angular acceleration is related to torque by T =Ia.
对于绕主轴转动的刚体来说，角加速度与转矩的关系是T＝Ia。
New Research on the Velocity of Money during the Transition Times:Prospective of Institution;
转型中的中国货币流通速度新探索：制度视角——兼论“中国之谜”
The desired output information was a measure of slew-rate or angular-velocity input and not position.
所要求的陀螺输出是旋转速率或角速度输入的量度，而不是位置的量度。
This is to be completed in the time it takes the body to roll to, decelerate, and stop at the maximum rotation angle and then to accelerate and roll in the opposite direction.
这个动作在身体滚动的同时完成，减速，并在最大转动角度停止然后加速并转动到另一边。
A linear filter is adopted in the system to obviate the measurement of angle acceleration and to achieve the closed-loop speed control.
系统实现时，构造了一个线性滤波器以避免转子角加速度的测量，同时实现了转速的闭环跟踪。
A Probe Into the Speed and Speed Endurance Through the Biochemical Basis;
从生化角度探讨速度及速度耐力训练
The rotational angle of a ball around its rotational axis.
转轴角-----球旋转时转轴的水平角度。
