Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
Oil may be forced out through the timing cover and rear-main bearing oil seals.
机油会从正时齿轮盖和后主轴承油封处压出。
upper center crankshaft bearing
曲轴主轴承上中轴瓦
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
Crankshaft and main bearings service
曲轴和主轴承的维修
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
"Semifinished main bearings require finishing and fitting after installation, so that the crankshaft must be taken out."
半精加工的主轴承安装后需要修整和调配,这样曲轴就必须拆下。
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
Experimental Investigation into the Transient Response of a Flexible Rotor Dropping on a Back-up Bearing After Active Magnetic Bearing Failure
主动电磁轴承失效后柔性转子坠落在备用轴承上的瞬态响应实验研究
main drive gear bearing oil slinger
主动齿轮轴承抛油环
drive pinion cone bearing
主动小齿轮锥形轴承
differential drive pinion cage bearing
差速器主小齿轮轴承罩
Many bearing difficulties can be taken care of by this method of bearing replacement.
许多轴承故障能够通过更换主轴承或轴承来解决。
Our main products are spherical roller bearing, tapered roller bearing and deep groove ball bearing.
主要生产圆锥滚子轴承、调心滚子轴承、深沟球轴承。
Our main products are taper roller bearing, spherical roller bearing and deep groove ball bearing.
主要生产圆锥滚子轴承、调心滚子轴承、深沟球轴承等。
